Dang Ranger....

[Dan B.]

The 1990 acted up again today. Couple months ago it was an oil pump. Went to leave work, started it and it would not idle. Motor jumps around then shuts off. If I start it, instantly bring the RPMs up to 2500+ it will run just fine. Put a load on it and it dies. It's acting like it jumped time at low rpm. It fuel were a problem it wouldn't run at high rpm. I'm going to dig into it tomorrow night. Right now it's in the work parking lot and Cindy brought me home. Taking the trailer tomorrow.

[Martin0660]

It's the curse of the 2.3 .... how anything so simple could be so complicated ....

[PaxtonShelby]

Three
Forty
Seven

[95V6]

460....

[John4cam]

Lsx.

[PaxtonShelby]

The tribe has spoken.

[JeffreyCole]

4g63.......?:hellothere::hellothere:

[Dewayne]

Hamster Wheel.......(Probably make alot more power)

[RUTHLESS]

Since we are all dreaming... I say go 2jz-gte just to be a little different while using a killer engine.

[Cam99]

Slant 6

[PaxtonShelby]

...because racetruck...

[RUTHLESS]

...because racetruck...

A mini farm truck would be cool.

[Dan B.]

Three
Forty
Seven

Meh........


Lsx.

I'd rather change my name to Caitlyn Jenner.


Hamster Wheel.......(Probably make alot more power)

It would be close.........how long is the life span of a hamster??

Here's what I'm thinking..........

26555

[Dan B.]

Good thing we have a big parking lot at work............

26556

[PaxtonShelby]

A mini farm truck would be cool.

He's already working on one of those. No kidding!!

[JeffreyCole]

I'd rather change my name to Caitlyn Jenner.

This is going in my sig for SURE.

[Tom]

http://i.imgur.com/qN5HWXMl.jpg

[phillysrt4]

once you go coyote you never go hello kitty license plate frame! :)

[Dan B.]

Ok. Letz git cereal uh minit.

Did some investigating. There is fuel to the rail. Redneck method shows 30#. Timing light shows idle timing all over the place. Everywhere from 0 to 20 btdc. Bring the rpm's up to 2500+ it settled in to 25 degrees rock steady. Then a few minutes later the idle smoothed out but timing was 20 btdc.

Took on a drive down the road and at higher rpm it runs great. Let it drop below 2500 and it bucks and surges terrible.

Thoughts?

[Dan B.]

Checked the timing marks. Crank on 20. Cam and oil pulleys on their marks.

[jaa55]

Since the oil pump went bad, I would pull distributor cap off and wiggle the rotor to see if you have a lot of play. Maybe something is wrong on the bottom of the distributor. Another thing to try is pull the spout wire to see if it will settle the jumping around. Timing belt ok?

[Dan B.]

No dizzy. It's a twin plug, twin coil pack truck.

I replaced the oil pump b/c the pick up tube clogged and likely starved it. Just did both. Didn't do the timing belt though. The belt looks ok but some how the crank pulley is 20 degrees out.

[jaa55]

I kept jumping time on my turbo coupe because it didn't have a cover on the belt. I was getting rocks up in it or something

[Dan B.]

Fixed.

Lined up up all the timing marks, put belt back on and runs good. I'll stick a new belt on it but just wanted to make sure my diagnosis was right. The belt actually looked really good and the tensioner was fine.

[George C]

Meh........



I'd rather change my name to Caitlyn Jenner.





]

not everyone can handle going fast or having power so id say stick to a ford motor for the tamer power levels

[Dan B.]

not everyone can handle gay sex or being ramroddedso id say stick to a ford motor for lots of vagina and heterosexual activities

thanks for the advise.

[George C]

thanks for the advise.

dont forget....
Faggots
Only
Ride
Dicks


before the next editing....:)

[2000GT]

.........

[Troll]

dont forget....
Faggots
Only
Ride
Dicks


before the next editing....:)
here's your thread Dan. I don't see how you can't build a good relationship with the above quote... :hugsandkisses"