E cam

[Rio94gt]

Nobody would happen to have an E303 Cam laying around?

[gmkillr]

Nobody would happen to have an E303 Cam laying around?

Dude if you must use an o.t.s. cam then get an Anderson cam ($300, or if you wanna be real cheap then get a f-303($190) its suited towards blower cars, just remember your gonna need a new set of lifters too($120) and possibly pushrods($87) Timing chain ($60-90)

[yeahloh95]

some 94-95 cars really don't like the e-cam a all . i have a comp cam part number for $239 if you want a great blower cam.

[Rio94gt]

What about the steeda 19?

[Killercanary]

Many guys get the steeda 19 cam, but I've never seen anyone make stellar numbers with it, most are usually disappointed. Plus, at $200 you are not that far away from what a custom cam will cost you. A custom cam normally pays for itself in the additional tech support and help you receive from the maker. I have had nothing but the best experience with Ed Curtis of http://www.flowtechinduction.com The $325 I spent on the cam was by far the best money I have ever spent on the car, because I not only got a cam that far exceeded my expectation in terms fo power, driveability, etc but the tech support I got from Ed is priceless.

I too would not recommend the E303, a LOT of 94-95's owners develope horrible surge and die idle's with it.

[J-rod]

I too would not recommend the E303, a LOT of 94-95's owners develope horrible surge and die idle's with it.


that 95 GT i wanted had that problem.

[Rio94gt]

Well let the search possibly continue. I may not even put one in. Was just kicking the idea around.

[J-rod]

there is a steeda 18 fs on page 3 of classifieds

[yeahloh95]

the comp cam i was talking about is an off the shelf blower grind ,it worked for a year in my car with no tune:goodidea: its a 114 centerline 544 lift :pepper:

[gmkillr]

Your springs are only good to .542 lift so you would more than likely run into some valvetrain troubles.

[yeahloh95]

its only 533 on the intake:thumbsup:

[mikeymustang]

I have run both the Trick FLow Stage 1 and the Stage 2 (now) and both worked well for a cheap off the shelf cam

Mike

[gmkillr]

This is a somewhat descent cam for our year cars.
Crane 2031
http://www.corral.net/forums/showthread.php?t=884635

[Rio94gt]

I thank everyone for their help but i think ive decided to leave the stocker in there. Its gonna cost me way to much money for what its worth. I really dont want to do anything else to this moter since it could explode at any minute. Ill put that money somewhere else.

[Killercanary]

I thank everyone for their help but i think ive decided to leave the stocker in there. Its gonna cost me way to much money for what its worth. I really dont want to do anything else to this moter since it could explode at any minute. Ill put that money somewhere else.


I think that is a GREAT idea.